What's new

Angie

Administrator
Staff member
I was recently asked to make a Beauty and the Beast cake and was looking for a swag/drape mould to incorporate into my design. So, after further research, I finally settled on this — the Triple Classic Swag Mold created by Marvelous Molds.

The mould is approximately 1800 mm wide x 450 mm deep, extremely bendy and has raised bladed edges to give you a better cut. This one is taken from their Swag Mold Collection.
Before use, I washed the mould in hot soapy water and left it to dry.

To use the mould you are required to lightly dust it with either cornflour/cornstarch or icing/confectioners sugar so that the icing fondant doesn’t...
Continue reading...
 
Last edited:

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

Top